Simple Operation: Lowering the Technical Barrier. The operation of the Dry fish feed production equipment is simplified to four steps: "raw material pretreatment - parameter preset - machine start-up - finished product discharge." No specialized technicians are required; operators can learn to operate it after a short training period (1-2 days). Its core parameters (screw speed, feed rate, and cutting speed) are easily adjustable, achieving one-button control via a frequency converter, eliminating the need to adjust complex parameters such as steam pressure and water volume (wet extruders require simultaneous adjustment of multiple parameters). For example, when producing starter feed for fish fry, simply replace the 1mm die, preset the screw speed to 250r/min and the feed rate to 80kg/h, and stable production can begin immediately after startup. To switch to adult fish feed, simply replace the 4mm die and adjust the screw speed to 350r/min; the setup time is only 10-15 minutes.
Simple Maintenance: No Professional Repair Team Required. The core components of the Dry fish feed pellet extruder machine (screw, extrusion chamber, die) are easy to disassemble and install. Routine maintenance only requires three steps: "cleaning - inspection - lubrication." After each production run, once the equipment has cooled to below 50°C, the die and screw can be disassembled for cleaning. Residual material can be removed using a soft nylon brush and a special cleaning needle, requiring no complicated tools. During regular inspections, simply observe the wear on the screw threads and whether the die bore is deformed to assess the condition of the components. Lubrication maintenance only requires adding lubricating oil to the motor bearings and screw bearings, a simple process. For example, a family fish farmer can complete daily cleaning and maintenance themselves, without hiring professional repair personnel, saving 2000-3000 yuan in maintenance costs annually.
High equipment stability: Low failure rate. The Dry Type fish feed pellet processing machine has a simple structure and few moving parts, resulting in a significantly lower failure rate than wet extruders (wet extruders require multiple auxiliary devices, leading to more potential failure points). Common failures are limited to simple issues such as screw jamming and die blockage. Users can learn troubleshooting methods by referring to the equipment manual or through short-term training, eliminating the need to stop the machine and wait for professional repairs. For example, when the screw jams, the user only needs to turn off the power, allow it to cool down, disassemble the screw to clean the residual material, check the moisture and particle size of the material, and then restart the machine. The troubleshooting time is only 30-60 minutes. However, if a wet extruder experiences a steam boiler or dryer malfunction, the troubleshooting time can take several hours or even days, seriously affecting the production schedule.
About Us
Customer visit
Certificate of Honor
Your message must be between 20-3,000 characters!
English
