company news about The basic operation and maintenance of the guillotine

Basic operation
1、Clear the hard objects such as wood sticks, iron, stones, etc. that are entrapped in the material when feeding.
2、According to the length of the material you need, install and debug the gears.
3、Turn on the power source, make the machine idle for a few minutes, there is no abnormality and then feed evenly; too much is easy to cause overload stop, too little affects the efficiency.
4, stop working, should first stop feeding, and then let the machine idle for two minutes, blowing clean within the dust, weeds, and then shut down the machine.

Maintenance

1、Before use, first check whether the links of each part are reliable and whether there is any collision in the rotating parts.
2、Regularly check whether the bolts and nuts are firm, and tighten them immediately if there is any loosening.
3、The place where each part of the machine needs lubrication should pay attention to lubrication frequently, the lubricant in the gear box should be replaced once a season, and the main bearing should be cleaned and filled with lithium grease every year.
4、Make sure to remove the dust and debris inside when refilling the lubricant.
5、Moving and fixed knives should be kept sharp, replaced or sharpened in time after using blunt, when sharpening moving knives should be ground beveled, fixed knives ground above.
6, check each part for wear and tear, deformation, such as problems found should be given timely replacement.
7, at the end of the operation, should let the host idle for a period of time, blow the dust and weeds in the machine, and then cut off the power.