1.If the raw material has lower moisture in sheep feed pellet production, adding atomized water when mix the material can improve the quality of feed pellet, reduce power consumption, and improve the economic benefits. The moisture content of feed pellet is affected by the raw material, store, and each production processing link in the process of producing, so the moisture control must be strengthened.
2.In the actual sheep feed production, if the powder material has lower moisture content, we need reduce the steam pressure and close all traps to improve the moisture content of feed pellet. If the powder material has higher moisture content, we need use the high pressure over-saturation steam to control the moisture.
3.The purpose of the cooling process is not only to reduce the temperature of the pellet feed so that it does not exceed the room temperature of 3℃; it can also take away the moisture in the feed, so that the moisture of the feed product meets the specified requirements, and set the cooling parameters of the finished product according to the moisture before the finished product is cooled .
To avoid excessive water loss.If the feed pellets are too dry and small, we should reduce the quantity of wind, and cooling time should shorter than normal. If not, increase the quantity of wind, and take more time to cooling. Ensure the pellets get the same cooling time, and operate strictly according to the operation requirement of the cooler. If the raw material has lower moisture, adding atomized water when mix the material can improve the quality of feed pellet, reduce power consumption, and improve the economic benefits. The moisture content of feed pellet is affected by the raw material, store, and each production processing link in the process of producing, so the moisture control must be strengthened.
Contact Person: Fiona
Tel: 86 19913726068
