company news about Guillotine machine common causes of failure and troubleshooting methods

Fault one.
Solve the causes of the guillotine guillotine out of the grass length uneven 1, if you guillotine is a relatively hard grass such as corn straw, check whether your blades have wear, need to re-sharpen the knife. If the blade is seriously worn, you need to replace the blade again. 2, if the first method can not solve the problem, you can adjust the feed speed and rotor speed. 3, if you guillotine is rice straw, wheat straw and other softer grass, it is reasonable to appear uneven length, because the rice straw irregular feed, there will be molded into the situation, from the gap of the knife leakage guillotine. This situation notice change the gap between the moving knife and fixed knife, and sharpen the blade, so that the blade sharp can improve the problem.

Failure II.
Guillotine bearing overheating failure causes failure causes: too much grease, guillotine too little or grease bad; bearing damage; elimination methods: add grease as required; replace the bearing; straighten the spindle, balance the rotor; replace the oil seal; reduce the amount of feeding; adjust properly. Cause the rotor unbalance. Elimination methods: optional hammer blade, green storage guillotine more, so that the weight difference does not exceed 59; hammer blade can be flexible rotation; replace the bearing; straighten or replace; balance the rotor. Guillotine stalling, sound abnormal failure causes failure causes: fastening guillotine screws loose; blade clearance is too small; metal, common failures stones and other hard objects into the machine. Elimination method: check whether the blade, fastening screws are loose; loose should be tightened, adjust the blade clearance to the standard requirements; stop inspection, open the machine shell to exclude foreign objects.